Powis Parker FastBack Model 11 Manuel de l'opérateur télécharger pdf (Page 8)

MODEL 11 KEY OPERATOR’ S MANUAL 7

III INSTALLING THE MACHINE

1. Remove the two foam blocks from between the Book Clamps.The

Book Clamps can be easily opened with finger pressure.

2. Check to see that the Power Switch is “Off” by depressing the side of

the Power Switch marked “O”.The Power Switch is located at the

lower left front corner of the machine (figure 1 page 3).

3. Install the Book Fence by positioning it on the two brackets on top of

the rear Book Clamp. Press it straight down until it clicks into place.

4. Install the Cooling Rack. (NOTE: The Cooling Rack can be used by

placing it on top of the machine, or free-standing.) To install the

Cooling Rack on the machine, simply place it on the top rear surface of

the machine, behind the rear Book Clamp. Gently push it back, until

the front flange of the Cooling Rack clips into place.

5. Plug the Power Cord into the outlet on the back of the machine.

Then connect the Power Cord to a standard, grounded electrical outlet.

To Operate the Machine

1. Turn the Power Switch to the “On” position.

2. Allow the machine to warm up (3 – 4 minutes).

When the Book Clamps open, your Fastback

Model 11 document

binding machine is ready for use.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 22 23

Pas de commentaire

Powis Parker FastBack Model 11 Manuel de l'opérateur Page 8