Powis Parker FastBack Model 11 Manuel d'instructions télécharger pdf (Page 9)

SCORER USER’S MANUAL

Perfectback™LF strips produce a cover spine that hinges freely

from the bound spine of your book block. Thus, the spine portion

will lay flat when the book is opened. LF

strips do not require

heat for the final binding step, so you have the greatest freedom

to choose your cover material or printing method.

These strips are easily identified by the two thin bands of release

paper, one on each side of the back of the strip.

After binding your document pages in a Fastback® binder, with our

Perfectback™LF strip, you need to score your book cover so it fits

nicely around your bound book block. Our Centering Guide

enables you to easily and accurately locate scores for books up to

1-1/2 inches thick. This is especially helpful as your book thickness

may be a bit different from what you expected due to the buildup

of ink or paper thickness variations. The Centering Guide may be

used with either the Single Die Holder or the Double Die Holder.

Operation with the Double Die Holder is the suggested mode and

will be explained first. It makes your spine edge scores based on

your document’s thickness — it also simultaneously makes

secondary appearance scores 3/16” from the spine edge on your

front and rear covers.

A Demonstration Cover in your Accessory Pack summarizes

how to prepare and assemble a book.

A. DOUBLE DIE HOLDER USE

Scoring Your Cover

1. With your Fastback®binder set in PERFECTBACK mode, bind

only your pages with a Perfectback™LF strip.

2. After it has cooled, place your bound book block between the

Book Thickness Rings (figure 8). Push the two rings together

(A) and tighten the Book Thickness Locking Knob (B).

Remove your book block.

3. Slide your cover under the transparent bar until your title is

centered between the two silver lines (figure 9). The bottom

of your cover must rest against the Left Stop and the Guide

Rail. Push the Lever to the right to clamp your cover in place.

4. With the Centering Guide Lock unlocked, slide the Centering

Guide under your cover until the cover right edge (A) lines up

with the middle of the X (figure 10). Then tighten the

Centering Guide Locking Knob (B).

5. Bring the Lever upright to unclamp the cover. Slide the cover

over so its right edge (A) stops against step 1 (figure 11).

Push the Lever to the left (B) to make a score.

Slide your cover over again so its right edge (A) stops against

step 2 (figure 12). Push the Lever to the left (B) to make

a score.

The distance between the two middle scores on your cover is the

same as the thickness of your book.

Assembling your Document

The instructions on the next page explain how to complete making

your book by assembling your scored cover to your bound book

block.

USING PERFECTBACK™ LF

(lay flat) STRIPS

F I G U R E 9

F I G U R E 11

F I G U R E 12

F I G U R E 8

F I G U R E 10

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 26 27

Commentaires sur ces manuels

Pas de commentaire

Powis Parker FastBack Model 11 Manuel d'instructions Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à relier Powis Parker FastBack Model 11