
SCORER USER’S MANUAL
15
USING PERFECTBACK™ PS
STRIPS (continued)
VI
Assembling your Document
1. With your cover and the Centering Guide in their
last positions, slide your cover over so its right
edge stops against step 3 (figure 60). Push the
lever to the right to hold down your cover.
2. Peel off the thin release paper (figure 61) from
the front of your bound book block,
3. Fold your cover up to the left so it rests against
the side of the Die Holder (figure 62). Run your
finger back and forth at the bottom at the spine
area of the cover so it makes a sharp fold at the
bottom.
4. Lay the book block, front facing up, on the right
side of the Platform with its bottom edge resting
against the Guide Rail (figure 63). It is OK if part
of it rests on top of the Centering Guide.
Push the spine of the book block against the
spine portion of your cover that is folded up.
5. With the book spine pushed fully and firmly to
the left, fold the cover over your book block
(figure 64). Starting at the middle, rub down
back and forth to secure the cover to the
adhesive.
6. Release the clamp by bringing the Lever to the
upright position. Remove the partially bound
book and turn over. On the back side remove
the remaining wide release paper (figure 65).
7. Fold the back cover up tight against the book
block spine end (figure 66). Rub back and forth
to bind the cover to the adhesive beneath it.
Now fold the cover tightly all the way over the
top of the book block. Rub back and forth on
top near the spine to bind the adhesive beneath
the cover (figure 67).
8. Trim the book ends as desired.
Handheld document assembly
This is an alternate method of assembly which some
people prefer. It does not require an assist from the
machine. Refer to page 11 for a description.
F I G U R E 61
F I G U R E 60
F I G U R E 62
F I G U R E 63
F I G U R E 65
F I G U R E 66
F I G U R E 67
F I G U R E 64
Commentaires sur ces manuels