Powis Parker FastBack Model 11 Manuel d'instructions télécharger pdf (Page 18)

SCORER USER’S MANUAL

USING PERFECTBACK™ TA

(temperature activated)

Perfectback™TA strips bind your document without a gap

between your cover spine and book block spine. Since the final

binding is done at an elevated temperature in a Powis Parker

Fastback®binder, you must use cover materials and printing

methods that are not heat sensitive. (If that is not possible, then

you can use our LF or PS strips — they do not use heat for the

final binding step.) If you have any uncertainties, try a practice final

binding to see if you get satisfactory results.

TA strips can be identified by the plain looking back of the strip.

There are no release paper pieces.

After binding your pages, you need to score your book cover so it

fits nicely around your bound book block. Our Centering Guide

enables you to easily and accurately locate scores for books up to

1-1/2 inches thick. The Centering Guide may be used with either

the Single Die Holder or the Double Die Holder.

Operation with the Double Die Holder is the preferred mode and

will be explained first. It makes the spine edge scores based on

your document’s thickness — it also simultaneously makes

secondary appearance scores 3/16” from the spine edge on your

front and rear covers.

A Demonstration Cover in your Accessory Pack summarizes

how to prepare and assemble a book.

A. DOUBLE DIE HOLDER USE

Scoring Your Cover

1. Using your Fastback®binder in PERFECTBACK mode, bind

only your pages with a Perfectback™TA strip.

2. After it has cooled, place your bound book block between the

Book Thickness Rings (figure 68). Push the two rings together

(A) and tighten the Book Thickness Locking Knob (B).

Remove your book block.

3. Slide your cover under the transparent bar until your title is

centered between the two silver lines (figure 69). The bottom

of your cover must rest against the Left Stop and the Guide

Rail. Push the Lever to the right to clamp your cover in place.

4. With the Centering Guide Lock unlocked, slide the Centering

Guide under your cover until the cover right edge (A) lines up

with the middle of the X (figure 70). Then tighten the

Centering Guide Locking Knob (B).

5. Bring the Lever upright to unclamp the cover. Slide your cover

over so its right edge (A) stops against step 1 (figure 71).

Push the Lever to the left (B) to score.

6. Slide your cover over again so its right edge (A) stops against

step 2 (figure 72). Push the Lever to the left (B) to make a

score. Remove your cover.

The distance between the two middle scores on your cover is the

same as the thickness of your book.

Assembling your Document

The instructions on the next page explain how to complete making

your book — with the assembly of your scored cover to the bound

book block.

NOTE: Figures 68 through 72

are the same instructions as

printed on the Scorer.

F I G U R E 69

F I G U R E 68

F I G U R E 70

F I G U R E 71

F I G U R E 72

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 26 27

Commentaires sur ces manuels

Pas de commentaire

Powis Parker FastBack Model 11 Manuel d'instructions Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à relier Powis Parker FastBack Model 11